Sample records for COLADA CERAMICA (slip casting)
from WorldWideScience.org

Sample records 1 - 14 shown.



1

Threshold strength evaluation on an Al2O3–ZrO2 multilayered system

Bermejo, R.; Torres, Y.; Baudín de la Lastra, Carmen; Sánchez-Herencia, A.J.; Pascual, J.
2007-01-01

Digital.CSIC (Spain)

3

Tensiones residuales en cerámicas multicapa de Al2O3-ZrO2: naturaleza, evaluación y consecuencias sobre la integridad estructural

Bermejo, R.; Sánchez Herencia, Antonio Javier; Baudín de la Lastra, Carmen; Llanes, L.
2006-09-01

Digital.CSIC (Spain)

5

Slip casting of barium zirconate aqueous concentrated suspensions

Boschini, F.; Guillaume, B.; Rulmont, A.; Cloots, R.; Moreno, R.
2006-01-01

Digital.CSIC (Spain)

6

Rheological Behavior and Slip Casting of Al2O3–Ni Aqueo Suspensionsus

Sánchez-Herencia, Javier A; Hernández, Nicolas; Moreno, Rodrigo
2006-01-01

Digital.CSIC (Spain)

7

Nickel Sheets from Suspensions of the Metallic Powders in Water

Mora Alfonso, Mario; Moreno, Rodrigo; Sánchez Herencia, Antonio Javier
2008-10-07

Digital.CSIC (Spain)

10

Estudio de sinterización del Y2SiO5

Aparicio Ambrós, Mario; Durán Carrera, Alicia Amparo
1998-02-01

Digital.CSIC (Spain)

11

El desafío de los materiales cerámicos

Moya Corral, José Serafín; Requena, J.
1998-08-01

Digital.CSIC (Spain)

12

Análisis por elementos finitos de alúmina sometida a esfuerzos mecánicos y térmicos

Tomba Martinez, A.G.; Cavalieri, A.L.
2001-01-01

Resumen en inglés Disks of a commercial alumina were fabricated by slip casting, calcination and sintering. The surfaces were machined using SiC papers (120 and 320 grit) and characterized by residual stresses measurements. The mechanical strength was determined in biaxial flexure (ball on discontinuous ring). The specimens were subjected to thermal shock conditions (cooling using a high-velocity air jet) and the critical temperature differential for crack propagation was determined. The t (mas) emperature and stress distributions during air impinging were calculated using a finite element method. The value of the heat transfer coefficient was estimated by fitting the calculated temperature profiles with those measured during each test. The calculated tension for the thermal shock fracture was compared with the mechanical strength, together with the fracture features in each case. The differences were explained on the basis of the calculated stress distributions.

Scientific Electronic Library Online (Spanish)

13

AlN ceramics processed by aqueous slip casting

Olhero, S. M.; Miranzo, Pilar; Ferreira, J. M. F.

Fully dense aluminium nitride (AlN) ceramics consolidated by aqueous slip casting were obtained after sintering at 1750°C for 2h. The obtained samples were characterized by Vickers hardness (1000 Hv), flexural strength (200 MPa) and thermal conductivity (115 W/mK). YF3 and CaF2 were used as sinterin...

DRIVER (Spanish)

14

AlN ceramics processed by aqueous slip casting

Olhero, S. M.; Miranzo, Pilar; Ferreira, J. M. F.
2006-10-01

Digital.CSIC (Spain)