WorldWideScience
 
 
1

Behavior study of polyphenols from Maytenus aquifolium due to X and gamma radiations; Estudo do comportamento dos polifenois de espinheira santa (Maytenus aquifolium) frente as radiacoes x e {gamma}  

Energy Technology Data Exchange (ETDEWEB)

Short communication.

1995-12-31

2

Study of Maytenus aquifolium martius chemical compounds stability face to ionizing radiations (x radiation and gamma radiation); Estudo da estabilidade dos compostos quimicos de Maytenus aquifolium martius frente a radiacao ionizante (X e Y)  

Energy Technology Data Exchange (ETDEWEB)

No abstract prepared

1996-09-01

3

Treatment and Course of Community-Acquired Pneumonia Caused by Atypical Pathogens  

British Library Electronic Table of Contents (United Kingdom)

Objetivo Estudiar la evolucion de un grupo de neumonias extrahospitalarias causadas por germenes atipicos (Mycoplasma pneumoniae, Legionella spp., Coxiella burnetii y Chlamydophila pneumoniae) en funcion del tratamiento empirico recibido. Pacientes y metodos Entre enero de 1996 y febrero de 2001 ingresaron en nuestra unidad 390 casos de neumonia, de los que 89 estaban causados por germenes atipicos. Los pacientes se dividieron retrospectivamente en 2 grupos segun el tratamiento empirico pautado: grupo A, al que se habia proporcionado cobertura frente a germenes atipicos (quinolonas o macrolidos), y grupo B, al que no se habia proporcionado dicha cobertura. Se estudio la evolucion segun las diferencias entre ambos grupos en la estancia hospitalaria, la resolucion radiologica, el reingreso e...

2006-01-01

4

Comparison of sliding friction and wear behaviour of overhead conveyor steels tested under dry and lubrication conditions; Comportamiento frente al desgaste y friccion de aceros empleados en lineas de manutencion aerea ensayados con y sin lubricacion  

Energy Technology Data Exchange (ETDEWEB)

The sliding friction and wear behaviour of different steel qualities were investigated with and without lubrication conditions. Steel qualities tested are normally used in the overhead conveyor system of many industrial fields, like the automotive sector. Sliding wear tests have been conducted by means of a pin-on-disk machine. A 100Cr6 steel similar to that used within the overhead conveyor trolleys has been employed as a pin. Friction coefficient values obtained under lubrication conditions were three times smaller than those obtained without lubrication. The mechanism that controls wear behaviour under lubrication conditions is an abrasive one and the wear values obtained are almost worthless. On the other hand, mechanism controlling wear during non lubrication tests, was a combination of abrasion and adhesion. (Author) 20 refs.

2005-07-01