WorldWideScience
 
 
1

Method of pipe whip and impact analyses  

Energy Technology Data Exchange (ETDEWEB)

We successfully reproduce one of the French pipe whip experiments with the computer code WIPS. The WIPS results are in excellent agreement with the experimental data and the French computer code TEDEL. This justifies the use of its pipe element in conjunction with its U-bar element in a simplified method of impact analyses.

1983-11-21

2

Lattice QCD study of the scalar mesons a0(1450) and sigma(600)  

Energy Technology Data Exchange (ETDEWEB)

We study the a{sub 0} and {sigma} mesons with the overlap fermion in the chiral regime with the pion mass as low as 182 MeV in the quenched approximation. After the {eta} N ghost states are separated, we find that the a{sub 0} mass with q{bar q} interpolation field to be almost independent of the quark mass in the region below the strange quark mass. The chirally extrapolated results are consistent with a{sub 0}(1450) being the u{bar d} meson and K{sub 0}*(1430) being the u {bar s} meson. We also calculate the scalar mesonium with a tetraquark interpolation field. In addition to the two pion scattering states, we found a state at {approx} 550 MeV. Through the study of volume dependence, we confirm that this state is a one-particle state, in contrast to the two-pion scattering states. This suggests that the observed state is a tetraquark mesonium which is quite possibly the {sigma}(600) meson.

2007-12-01

3

Experimental studies of 4-inch pipe whip test under BWR LOCA conditions  

Energy Technology Data Exchange (ETDEWEB)

Pipe whip tests or jet discharge tests have been performed at the Japan Atomic Energy Research Institute, which simulate the instantaneous circumferential guillotine break of primary coolant piping in nuclear power plants. The present paper describes the results of the pipe whip tests using test pipes of 4 inch diameter, under the BWR LOCA conditions, which were performed from 1979 to 1981. The tests were carried out at an initial pressure of about 6.8 MPa and an initial temperature of about 285/sup 0/C. The test pipe was 114.3 mm (4 in) in diameter, 8.6 mm in thickness and 4500 mm in length. The four pipe whip restraints used in the tests were the U-bar type of 8 mm in diameter and frabricated from Type 304 stainless steel. The experimental parameters were the clearance (30, 50 and 100 mm) and the overhang length (250, 400, 550 and 1000 mm). The main purpose of these tests is to investigate the effects of the clearance and the overhang length on the pipe whip ...

1983-10-01